TM 5-3805-298-23-1
0097
Table 1. 600 Hydraulic Oil Temperature Sensor Diagnostic Codes - Continued.
097
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
5. Using MSD, check for active
Diagnostic Code 600-3 Hydraulic Oil
600-4 Hydraulic Oil Temper-
diagnostic codes (WP 0008).
Temperature Sensor Voltage Is
ature Sensor Voltage Is
Above Normal Becomes Active -
Below Normal or Shorted
Replace hydraulic oil temperature
Low - Continued
sensor (WP 0243).
Proceed to Test Step 5.
Diagnostic Code 600-4 Hydraulic Oil
Temperature Sensor Voltage Is
Below Normal Remains Active -
Proceed to Test Step 3.
Test Step 3. Test for Shorted Engine
Wiring Harness.
1. Remove right lower cab access
panels (WP 0347).
2. Disconnect connector EN-C8
(WP 0012, Figure 22) from
connector C-C19 (WP 0012,
Figure 23).
3. Disconnect connector EN-C2
(WP 0012, Figure 12) from
connector C-C18 (WP 0012,
Figure 13).
4. Using digital multimeter
Continuity - Replace engine wiring
(WP 0174), test for continuity
harness (WP 0299).
between connector EN-C8
Proceed to Test Step 5.
(WP 0012, Figure 22) terminal 2
No Continuity - Proceed to step 5.
and connector EN-C2 (WP 0012,
Figure 12) terminal 17.
5. Using digital multimeter
Continuity - Replace engine wiring
(WP 0174), test for continuity
harness (WP 0299).
between connector EN-C8
Proceed to Test Step 5.
(WP 0012, Figure 22) terminal 2
No Continuity - Proceed to Test Step 2.
and ground.
Test Step 4. Test for Shorted Lower
Cab Wiring Harness.
1. Remove left lower cab access
panels (WP 0347).
2. Remove transmission ECM cover
(WP 0266).
3. Disconnect connector C-C12
(WP 0012, Figure 26) from
Transmission ECM J1.
0097-7