TM 5-3805-298-23-1
0097
Table 1. 600 Hydraulic Oil Temperature Sensor Diagnostic Codes - Continued.
097
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
4. Using digital multimeter
600-3 Hydraulic Oil
Resistance 5.0 Ohms or Less -
(WP 0174), measure resistance
Proceed to Test Step 5.
Temperature Sensor Voltage
between connector EN-C8
Is Above Normal or Shorted
Resistance Greater Than 5.0 Ohms -
(WP 0012, Figure 22) terminal 2
High - Continued
Replace engine wiring harness
and connector EN-C2 (WP 0012,
(WP 0299).
Figure 12) terminal 17.
Proceed to Test Step 8.
Test Step 5. Test for Open Lower Cab
Ground.
1. Using digital multimeter
Resistance 5.0 Ohms or Less -
(WP 0174), measure resistance
Replace lower cab wiring harness
between connector C-C12
(WP 0291).
(WP 0012, Figure 26) terminal 23
Proceed to Test Step 8.
and ground.
Resistance Greater Than 5.0 Ohms -
Proceed to step 2.
Dirty, Corroded, or Loose - Clean and
2. Inspect ground connections
tighten as necessary.
(WP 0012, Figure 45) terminal 1
and terminal 2 for dirt, corrosion,
Proceed to Test Step 8.
and tightness.
No Problem Found - Replace lower
cab wiring harness (WP 0291).
Proceed to Test Step 8.
Test Step 6. Test for Shorted Engine
Wiring Harness.
1. Remove jumper wire from terminal
1 and terminal 2 of connector EN-
C18 (WP 0012, Figure 73).
2. Remove right lower cab access
panels (WP 0347).
3. Disconnect connector EN-C8
(WP 0012, Figure 22) from
connector C-C19 (WP 0012,
Figure 23).
4. Using digital multimeter
Continuity - Replace engine wiring
(WP 0174), test for continuity
harness (WP 0299).
between connector EN-C8
Proceed to Test Step 8.
(WP 0012, Figure 22) terminal 2
No Continuity - Proceed to Test
and all other EN-C8 terminals.
Step 7.
0097-4