TM 5-3805-298-23-1
0097
Table 1. 600 Hydraulic Oil Temperature Sensor Diagnostic Codes - Continued.
097
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
5. Turn battery disconnect switch and
600-5 Hydraulic Oil
ignition switch to ON position
Temperature Sensor Current
(TM 5-3805-298-10).
Is Below Normal - Continued
6. Using MSD, check for active
Diagnostic Code 600-4 Hydraulic Oil
diagnostic codes (WP 0008).
Temperature Sensor Voltage Is
Below Normal Becomes Active -
Replace hydraulic oil temperature
sensor (WP 0243).
Proceed to Test Step 5.
Diagnostic Code 600-5 Hydraulic Oil
Temperature Sensor Current Is
Below Normal Remains Active -
Proceed to Test Step 3.
Test Step 3. Test for Open Wiring
Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Remove left lower cab access
panels (WP 0347).
3. Disconnect connector C-C12
(WP 0012, Figure 26) from
Transmission ECM J1.
4. Using digital multimeter
Resistance 5.0 Ohms or Less -
(WP 0174), measure resistance
Replace transmission ECM (WP 0266).
between connector C-C12
Proceed to Test Step 5.
(WP 0012, Figure 26) terminal 30
Resistance Greater Than 5.0 Ohms -
and terminal 23.
Proceed to Test Step 4.
Test Step 4. Test for Open Engine
Wiring Harness.
1. Remove right lower cab access
panels (WP 0347).
2. Disconnect connector EN-C8
(WP 0012, Figure 22) from
connector C-C19 (WP 0012,
Figure 23).
3. Disconnect connector EN-C2
(WP 0012, Figure 12) from
connector C-C18 (WP 0012,
Figure 13).
0097-10