TM 5-3805-298-23-1
0126
Table 1. Front Right Turn Signal Does Not Operate.
0126
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
NOTE
Front Right Turn Signal
Does Not Operate
Always inspect wiring harness connectors that are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure and
that all connections are in good condition. If a problem with the
connection is found, correct the problem and verify that this malfunction
or diagnostic code is active before performing this procedure.
Perform open or short-circuit test at each wiring harness connection to
identify the correct wiring harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
Test Step 1. Test for Voltage at Front
Right Turn Signal.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Disconnect connector WH-C2RH
(WP 0012, Figure 148) from front
right turn signal (WP 0012,
Figure 149).
3. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-298-10).
4. Turn the military light switch to Ser.
Drive position and lower switch to
OFF (TM 5-3805-298-10).
5. Turn the turn signal switch to right
turn signal position (TM 5-3805-
298-10).
6. Using digital multimeter
Voltage Pulses Between 0 and 26
(WP 0174), test for voltage
Volts Replace front right turn signal
between connector WH-C2RH
light (WP 0273).
(WP 0012, Figure 148) terminal 1
Proceed to Test Step 5.
and terminal 2 (ground).
No Voltage Proceed to Test Step 2.
Test Step 2. Test for Voltage at Front
Frame Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Disconnect connector WH-C1RH
(WP 0012, Figure 150) from
connector LE-C8 (WP 0012,
Figure 151).
