TM 5-3805-298-23-4
0382
REMOVAL CONTINUED
WARNING
DO NOT disconnect or remove any hydraulic system hoses, tubes, or fittings unless
engine is shut down and hydraulic system pressure has been relieved. Tighten all
connections before applying pressure. Escaping hydraulic fluid under pressure can
penetrate skin.
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool before removing
any hydraulic fitting.
Wear protective eye covering and gloves.
The accumulator is filled with dry nitrogen. Do not loosen or remove valve or cap from
accumulator.
Failure to follow these warnings may result in injury or death to personnel.
NOTE
Remove adjacent accumulators as required to access defective accumulator.
2. Remove ride control accumulator (Figure 2, Item 3) and O-ring (Figure 2, Item 2) from ride control valve
(Figure 2, Item 1). Discard O-ring.
Figure 2. Ride Control Accumulator.
0382
END OF TASK