TM 5-3805-298-23-4
0383
REMOVAL CONTINUED
22. Remove fitting (Figure 9, Item 1) and O-ring (Figure 9, Item 2) from bucket tilt cylinder (Figure 9, Item 3).
Discard O-ring.
Figure 9. Bucket Tilt Cylinder Fitting.
0383
END OF TASK
CLEANING AND INSPECTION
000383
Clean and inspect all components IAW Mechanical General Maintenance Instructions (WP 0172).
END OF TASK
INSTALLATION
000383
WARNING
Lubricating/hydraulic oils used in performance of maintenance can be very slippery.
Immediately wipe up any spills. Failure to follow this warning may result in injury or death
to personnel.
NOTE
Both cylinders are installed in same manner. Right side shown.
1. Install new O-ring (Figure 9, Item 2) and fitting (Figure 9, Item 1) on bucket tilt cylinder (Figure 9, Item 3).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support. Keep clear of
heavy parts. Failure to follow this warning may result in injury or death to personnel.