TM 5-3805-298-23-4
0384
REMOVAL CONTINUED
13. Remove fitting (Figure 8, Item 2) and O-ring (Figure 8, Item 1) from bucket lift cylinder (Figure 8, Item 3).
Figure 8. Bucket Lift Cylinder Fitting and O-ring.
0384
END OF TASK
CLEANING AND INSPECTION
000384
Clean and inspect all components IAW Mechanical General Maintenance Instructions (WP 0172).
END OF TASK
INSTALLATION
000384
WARNING
Lubricating/hydraulic oils used in performance of maintenance can be very slippery.
Immediately wipe up any spills. Failure to follow this warning may result in injury or death
to personnel.
NOTE
Both cylinders are installed in same manner. Right side shown.
1. Install new O-ring (Figure 8, Item 1) and fitting (Figure 8, Item 2) on bucket lift cylinder (Figure 8, Item 3).