10
TM 5-3805-298-23-4
FIELD MAINTENANCE
-
BUCKET CLAMSHELL CYLINDER REPLACEMENT
0391
Removal, Cleaning and Inspection, Installation
INITIAL SETUP
Tools and Special Tools
Materials/Parts - Continued
0
0
Tool Kit, General Mechanic's
O-ring, 3J-1907 (WP 0432, Item 109)
0
(WP 0431, Item 162)
O-ring, 6V-8397 (WP 0432, Item 140) (2)
0
0
Gloves, Rubber (WP 0431, Item 63)
0
Personnel Required
0
Pan, Drain (WP 0431, Item 89)
0
Two
Goggles
0
0
References
Materials/Parts
0
0
WP 0172
Cap Set, Protective (WP 0430, Item 4)
0
0
Grease, Automotive and Artillery (GAA)
Equipment Conditions
0
(WP 0430, Item 13)
0
Machine parked (TM 5-3805-298-10)
0
Rag, Wiping (WP 0430, Item 27)
0
Estimated Time to Complete
Tag, Marker (WP 0430, Item 35)
0
0
Cotter Pin, 096-1820 (WP 0432, Item 3)
1.0 Hr
0
0
REMOVAL
000391
WARNING
DO NOT disconnect or remove any hydraulic system hoses, tubes, or fittings unless
engine is shut down and hydraulic system pressure has been relieved. Tighten all
connections before applying pressure. Escaping hydraulic fluid under pressure can
penetrate skin.
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool before removing
any hydraulic fitting.
Wear protective eye covering and gloves.
Lubricating/hydraulic oils used in performance of maintenance can be very slippery.
Immediately wipe up any spills.
Failure to follow these warnings may result in injury or death to personnel.
NOTE
Cap or plug all hydraulic hose ends and fittings during removal.
Use container to catch any fluid that may drain from hydraulic system. Dispose of fluid IAW
local policy and ordinances. Ensure all spills are cleaned up.
Both cylinders are removed in same manner. Right side shown.
0391-1