TM 5-3805-255-14
0018
Table 1. Field PMCS for the H100C Loader - (Continued).
LOCATION
ITEM TO
NOT FULLY MISSION
CHECK/
SERVICE
CAPABLE IF:
ITEM NO. INTERVAL
PROCEDURE
Quarterly
Transmission Oil
18
WARNING
Filter Change
When servicing this equipment, performing maintenance, or
disposing of materials such as engine/hydraulic oils, coolant,
and fuel, consult your unit/local hazardous waste disposal cen-
ter or safety office for local regulatory guidance.
Engine/hydraulic oils, coolant, and fuel can be very slippery.
Immediately wipe up any spills. Failure to follow this warning
may result in injury to personnel.
Transmission and oil may be hot. Use gloves to prevent injury.
NOTE
Filter is located on left-hand side of loader.
a. Drain transmission oil as described Class III transmission oil leak
under "Transmission Oil Change" in
is evident.
this work package.
b. Clean area around filter head.
Remove drain plug. After filter has
drained, install plug.
c. Remove four screws securing body
to head. Separate body from head.
d. Remove element from body.
Remove and discard O-rings and seal
ring.
0018-22
