TM 5-3805-255-14
0018
Table 1. Field PMCS for the H100C Loader - (Continued).
LOCATION
ITEM TO
CHECK/
NOT FULLY MISSION
SERVICE
CAPABLE IF:
ITEM NO. INTERVAL
PROCEDURE
Bimonthly
Service Brakes
27
Power Cluster
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an envi-
ronmentally compliant and low-toxicity material. However, it
may be irritating to the eyes and skin. Use protective gloves
and goggles. Use in well-ventilated areas. Keep away from
open flames and other sources of ignition. Failure to do so may
result in injury or death to personnel.
Particles blown by compressed air are hazardous. DO NOT
exceed 15 psi (103 kPa) nozzle pressure when drying parts
with compressed air. Use a maximum of 30 psi (207 kPa) when
cleaning components. DO NOT direct compressed air against
human skin. Make sure air stream is directed away from user
and other personnel in the area. User must wear protective
goggles or face shield.
Failure to follow these warnings may result in injury or death to
personnel.
CAUTION
Trapped air in hydraulic brake lines between service brake
power cluster and wheel cylinders reduces braking
effectiveness. Bleed the brakes (WP 0059).
NOTE
Procedure is same for all power clusters.
a. Clean area around filler plug and
Class III oil or air leak is
remove plug.
evident.
b. Check fluid level. Correct level is
3/8 to 1/2 in. (9 to 13 mm) from top of
housing. If necessary, add fluid. Refer
to Table 6, Lubricants, in this work
package for grade and quantity of fluid
required.
0018-36