TM 5-3805-255-14
0018
Table 1. Field PMCS for the H100C Loader - (Continued).
LOCATION
ITEM TO
NOT FULLY MISSION
CHECK/
SERVICE
CAPABLE IF:
ITEM NO. INTERVAL
PROCEDURE
ARTICULATION
AREA
Bimonthly
Intermediate
25
WARNING
Drive Block Oil
Check
When servicing this equipment, performing maintenance, or
disposing of materials such as engine/hydraulic oils, coolant,
and fuel, consult your unit/local hazardous waste disposal cen-
ter or safety office for local regulatory guidance.
Engine/hydraulic oils, coolant, and fuel can be very slippery.
Immediately wipe up any spills. Failure to follow this warning
may result in injury to personnel.
Intermediate drive block and oil may be hot. Use gloves.
Failure to follow these warnings may result in injury to
personnel.
a. While lubricant is at operating
temperature park loader on level
ground, completely lower bucket, and
apply parking brake (WP 0005).
b. Remove oil level gauge and wipe it Class III oil leak is evident.
clean.
c. Insert gauge as far as it will go.
d. Remove level gauge and check
lubricant level. If level is below full
mark, add lubricant as necessary.
Refer to Table 6, Lubricants, in this
work package for grade of lubricant
specified.
e. Fill block through level gauge hole.
Refer to Table 6, Lubricants, in this
work package for grade and quantity
of fluid required.
f. Install gauge.
0018-34
