8
TM 5-3805-255-14
FIELD MAINTENANCE
-
REAR FINAL DRIVE/PLANETARY ASSEMBLY REPLACEMENT
0056
Removal, Installation
INITIAL SETUP
References
Tools and Special Tools
0
0
Tool Kit, General Mechanic's, Automotive (WP
0
0128, Item 20)
0
0
Axle Removal/Installation Tool (WP 0125,
Equipment Condition
Item 4)
0
0
Machine parked on level ground (WP 0005)
0
Materials/Parts
Parking brake applied (WP 0005)
0
0
Rag, Wiping (WP 0130, Item 28)
Engine OFF (WP 0005)
0
0
Gasket
Battery disconnect switch in OFF position (WP
0
O-Ring
0
0
Stud, 1/2-13 N.C.2
Planetary oil drained (WP 0016)
0
0
Tubing, steel, 36 in. Long, 0-50 in. I.D.
Rear tire removed
0
0
Washer, Sealing (8)
Wheels chocked
0
0
Personnel Required
0
Two
0
REMOVAL
00056
WARNING
Align frame halves and install safety bar with wheels in straight-ahead position. Failure to
install safety bar could lead to serious injury or death.
Ensure wheels are chocked to prevent loader from moving.
1. Clean exterior of rear final drive/planetary assembly IAW General Maintenance Instructions (WP 0019).
2. Rotate planetary hub (Figure 1, Item 1) until drain filler plug (Figure 1, Item 2) is at bottom. Remove plug
(Figure 12) and drain lubricant into a suitable container. Remove O-ring (Figure 1, Item 3) from drain plug.
Discard O-ring.
Figure 1. Drain Plug Removal.
0056
0056-1