TM 5-3805-258-10 IMPLEMENT CONTROLS Bucket  Lift  Lever Bucket  Float  Position   -   Push the   lever   all   the   way   forward      into detent for FLOAT. The bucket will   lower   to   the   ground   and follow  ground  contour. The  lever  will  remain  in  FLOAT  until  pulled out  of  detent.  The  lever  will HOLD when released. CAUTION NEVER use FLOAT position ect  bucket. then  return  to to  lower  a  load- Bucket   Lower   Position   – Push  the  lever  forward  from  HOLD position  to  LOWER  the  bucket The lever will return to HOLD when released. Bucket   Hold   Position   -   The           level will return to HOLD when released from either RAISE or LOWER. The bucket will rermain in the position it is in. Bucket   Raise   Position   -   Pull the lever back to RAISE the bucket.  Release  the  lever  to stop  lifting  the  bucket.  The  lever will return to HOLD- when released. The  lever  is  detented  in  the  full  raise position. It will stay in detent until the bucket  reaches  height  set  by  the  lift  kickout. Then it returns to HOLD. Bucket Tilt Lever Bucket  Tilt  - -   Push   the   lever DUMP the bucket. Bucket  Tilt  - Dump Position forward  to Hold  Position   - Release  the  tilt  lever.  The  bucket will  remain  in  the  position  it  is  in.       Bucket Tilt – Tilt Back Position  -  Pull  the  lever  back  to tilt  the  bucket  back. Bucket Control  Lever       Bucket Open Position - Push the lever  forward  to  OPEN  the  bucket.      Bucket Hold Position - Release the  bucket  control  lever.  The  bucket will remain in the position it is in.     Bucket Close Position - Pull the lever back to close the bucket. 32