TM 5-3805-258-24-2
ENGINE
FUEL INJECTION PUMP
4. Remove the nut and disconnect cable assembly
(5) from the governor control lever.
5. Remove the bolts and disconnect bracket as-
sembly (6) from the governor.
6. Disconnect pressure line (7) at the fuel ratio
control.
7.
8.
9.
10.
11.
12.
13.
1
Put a mark on wires (9) and disconnect them
from the fuel shutoff solenoid.
Disconnect wires (8) from the alternator.
Remove clamps (11) and tube assemblies (10)
and (12) from the engine.
Remove the bolt and disconnect clip (16).
Disconnect tube assemblies (13) and (14) and
hose (15).
Remove bolts (18) and nuts (17) that hold the
fuel injection pump and governor in place.
Remove nut (19), the bolt (other side not
shown) and heat shield (20) from the engine.
DISASSEMBLY AND ASSEMBLY
HOUSING AND GOVERNOR
5-93
