TM 5-3805-258-24-2POWER TRAINDISASSEMBLY AND ASSEMBLYDRIVE SHAFT CARRIER BEARING9. Remove O-ring seal (10) and bearing (9) fromhousing (7).10. Remove lip type seal (11) from housing (7).INSTALL DRIVE SHAFTCARRIER BEARING3267-12Tools NeededA1P520Driver Group1NOTE: Models 950BS and 950BNS use a dif-ferent type seal than models 950BSCE and950BNSCE. Maintenance procedures shownhere will work for all models.1. Use tool group (A) to install the seal in housing(1). Make sure the lip of the seal is toward theoutside as shown.CAUTIONFor models 950BNS and 950BS, both lip typeseals for the carrier bearing housings mustbe Installed so the lips of the seais aretoward the front drive shaft at assembly tokeep grease out of the parking brake.2. Put clean grease on the lip of the seal and puthousing (1) in position over the front driveshaft.5-192
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business