VEHICLE SYSTEMSTM 5-3805-258-24-2DISASSEMBLY AND ASSEMBLYPILOT AND HYDRAULIC PUMPINSTALL PILOT ANDHYDRAULIC PUMP5073-121.2.3.4.5.6.7.8.9.Put O-ring seal (1) in position as shown.Use a hoist or two persons to put pilot andhydraulic pump (4) into position on the trans-mission pump. Make sure the splines on theshaft are in alignment with the splines in thetransmission pump.Install bolts (3) that hold the pump in position.Make sure the O-ring seal is in position andconnect hose assembly (2) to the pump.Make sure the O-ring seal is in position andconnect hose assembly (5) on the pump.Connect hose assemblies (6), (7) and (8) to thepilot pump.Make sure the O-ring seal is in position. Con-nect tube assembly (9) to the bottom of thepump.Install the floor panel under the seat.Fill the hydraulic tank to the correct level.end by: -a) install seat**This operation is in the 950B OPERATOR’S STA-TION DISASSEMBLY AND ASSEMBLY.5-395
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business