Vehicle SystemsTM 5-3805-258-24-2Disassembly and AssemblyAssemble Supplemental Steering PumpFOR IDENTIFICATION PURPOSES ONLYTools NeededA1P510 Drive GroupI1 IMandatory Replacement Parts Seal Kit1U2772QtyDescription2Seal (7/1 6 x 1-1/4” x 2“)1Snap Ring (1/16’’ thick x 2-7/32’’ O.D.)1O-ring (3/32” x 4-1/4” x 4-7/16“)4O-ring (1/16“ x 1-3/8” x 1-1/2”)1O-ring (5/64” x 15/32” x 5/8”)4Sealing Strip2Center Separator4End Separator4Backup Ring1Plug (13/64” X 7/16” Lg.)BACKUPENDCENTERSEALINGRINGSEPARTORSEPARATORSTRIP1. Make sure all of the parts of the hydraulicpump are clean and free of dirt and foreignmaterial before the pump is assembled.NOTE: See DIAGNOSING TYRONE GEARPUMP FAILURES, Form No. FEG45137, forassistance in inspection of the parts.2. Inspect all parts of the pump. Check thebores in the pump body. Measure the depthof grooves in each bore. If the grooves aredeeper than .015 in. (0.38 mm), areplacement of the pump body and gearsmust be made.5-394a
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business