TM 5-3805-258-24-2
OPERATOR’S STATION
DISASSEMBLY AND ASSEMBLY
FUSE PANEL
DISASSEMBLE FUSE PANEL
start by:
a) remove fuse panel
NOTE: Fuses can be removed and installed when the
fuse panel is in the machine.
1. Remove fuses as follows:
a) Push in on cap (1) and turn counterclock-
wise ¼ turn. Remove cap and fuse from the
fuse holder.
b) Remove fuse from the cap.
2. Remove fuse holders as follows:
a) Disconnect two wires (4) and (5).
b) Remove nut (3) and gasket. Remove fuse
holder (2) from the front of the panel.
3. Remove circuit breakers as follows:
a)
b)
c)
Disconnect two wires (6).
Remove two screws, nuts and lockwashers
(7).
Remove circuit breaker (8) from the panel.
ASSEMBLE FUSE PANEL
1. Install circuit breakers as follows:
a) Put circuit breaker (2) in position on the
fuse panel. Install the screws, lockwashers
and nuts that hold it.
b) Connect two wires (1) to the circuit
breaker.
5-494
