TM 5-3805-258-24-2OPERATOR’S STATIONHYDRAULIC CONTROL12.13.1 4.15.16.17.18.19.20.Install the nut, rod (17), nut and rod end (18)on rod (16). Before the nuts are tightened, turnthe rod so the distance from center to center forthe rod ends is 224 ± 1 mm (8.82 ± 0.04 in.).Install the bolts to hold levers ( 14) and ( 15) tothe rod ends.Put the key for lever (15) in position and installrod ( 16) and lever (15) on the shaft of the leverassembly. Tighten the bolt and locknut.Assemble control rod (20) and the levers as inSteps 12 and 13.Put the key for lever (19) in position and installrod (20) and lever (19) on the shaft of the leverassembly. Tighten the bolt and locknut.Use tool group (A) to install the bearings inbellcrank (21) and lever (22).Install rollers (25) and the locknuts on the leverand bellcrank.Put links (28) in position and install bolt (27) tohold a link to lever (22). Install pin (26) and thecotter pin to hold the link to bellcrank (21).Put washer (24), bellcrank (21), spacer (23),lever (22) and the other washer in-position inthe panel. Make sure the outside diameter ofwashers (24) are against the lever and bell-crank.NOTE: On models 950BNSCE and 950BSCE,install two additional washers (38) on eachside of spacer (23).DISASSEMBLY AND ASSEMBLYGROUP5-528
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business