TM 5-3805-262-10
3-4. GENERAL
a. The troubleshooting table (paragraph 3-5) lists common malfunctions which you
may find during operation of the loader. You should perform the tests/inspections
and corrective actions in the order listed.
b. This manual cannot list all possible malfunctions that may occur or all tests,
inspections,
and corrective actions. If a malfunction is not listed (except when
malfunctions and causes are obvious), or is not corrected by listed corrective ac-
tions, notify higher level maintenance.
3-5. TROUBLESHOOTING TABLE
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1. ENGINE WILL NOT CRANK
Step 1.
Check that transmission
control lever is in N
(neutral) position.
Step 2.
a. If transmission control
lever is in any position
other than N (neutral),
place it in N (neutral)
position.
b. If transmission control
lever is in N (neutral)
position, go to step 2
below.
Open radiator grille at rear of
loader.
Check for loose, corroded, or
damaged battery cables and con-
nections.
a. If battery cable connections
are loose, notify organiza-
tional maintenance.
b. If battery cables or connec-
tions are corroded or damaged,
notify organizational mainte-
nance.
c. If battery cables are okay, go
to step 3 below.
3-4
