TM 5-3805-262-20
INSTALLTION (SHEET 4 OF 4)
(16) Disconnect chain hoist nylon straps from cylinder assembly.
NOTE
R e p e a t s t e p s ( 1 ) t h r o u g h ( 1 6 ) a b o v e t o i n s t a l l r e m a i n i n g b u c k e t t i l t
cylinder assembly.
( 1 7 ) I f r i g h t c y l i n d e r a s s e m b l y i s b e i n g i n s t a l l e d , i n s t a l l r e t u r n - t o - d ig
control (page 11-15).
NOTE
Install new tie straps as necessary .
( 1 8 ) C h e c k h y d r a u l i c r e s e r v o i r o i l l e v e l;
add oil as necessary (page 11-78) .
(19) Tighten hydraulic reservoir fill cap and close and lock front access
door.
( 2 0 ) L u b r i c a t e p i v o t p o i n t l u b r i c a t i o n f i t t i n g s ( 1 ) ( r e f e r t o c u r r e n t l u b r i c a -
t i o n o r d e r ).
( 2 1 ) S t a r t e n g i n e a n d o p e r a t e a t i d l e s p e e d . S l o w l y e x t e n d a n d r e t r a c t c y l i n -
der assembly rods by placing BUCKET control lever alternately in DUMP and
CROWD positions. Do this four times to remove air from bucket tilt
cylinder assemblies.
(22) Turn off engine and check cylinder assemblies, hoses, lines, and fittings
f o r l e a k s . T i g h t e n f i t t i n g s i f n e c e s s a r y .
11-11
