TM 5-3805-262-20
ADJUSTMENT
a .
b .
c .
d .
e .
f .
g .
h .
i .
j .
k.
Ensure that bucket is resting flat on ground or floor.
Check that bracket (1) is fourteen inches from center of pivot pin (2) in rod
end of cylinder assembly. If necessary, loosen two capscrews and nuts (3) and
reposition bracket (1) as necessary. Tighten two capscrews and nuts (3).
If not already loose, loosen two nuts and capscrews (4) securing straps (5) to
cylinder assembly.
Move guide rod (6) up on cylinder assembly until micro switch (7) arm is not
in contact with actuating rod (8).
Move guide rod (6) down on cylinder assembly until micro switch (7) arm is
just in contact with actuating rod (8).
Hold guide rod (6) in position and tighten two nuts and capscrews (4) to
secure clamps (5).
Start engine and operate at 1500 rpm.
Place LIFT ARM control lever in RAISE position until bucket is at full height
then place BUCKET control lever in DUMP position to dump the bucket.
Place BUCKET control lever in CROWD position and LIFT ARM control lever in
FLOAT position. Bucket will lower to ground or floor.
Turn off engine.
Check position of bucket. If bucket is not flat on ground or floor, or is not
at correct digging angle, repeat steps a through j above.
11-17
