TM 5-3805-262-20
INSTALLATION (SHEET 2 OF 2)
(8)
Install new 0-ring (13) on two elbows (12).
(9)
Install two elbows (12) in tilt cylinder assembly ports and tighten se-
c u r e l y .
(10) Connect and finger tighten tube fitting (10) to elbow (12).
(11) Position saddle (9) between tube (11) and tilt cylinder assembly body. If
necessary, position tube (11) so that it is resting securely on saddle.
(12) Install new clamp (8) to secure saddle (9).
( 1 3 ) T i g h t e n t u b e f i t t i n g ( 1 0 ) s e c u r e l y .
( 1 4 ) I n s t a l l a n d t i g h t e n e l b o w ( 7 ) s e c u r e l y.
(15) Route and connect hose (6) between elbow (7) and tube fitting (5).
( 1 6 ) T i g h t e n h o s e f i t t i n g ( 4 ) a n d t u b e f i t t i n g ( 5 ) s e c u r e l y.
(17) Route and connect hose (3) between elbow (12) and tube fitting (1).
( 1 8 ) T i g h t e n h o s e f i t t i n g ( 2 ) a n d t u b e f i t t i n g ( 1 ) s e c u r e l y.
(19) Repeat steps (8) through (18) above to install and connect tube (11) and
hoses (3 and 6) to remaining tilt cylinder assembly .
(20) Tighten nuts (20 and 16)
( 2 1 ) F i l l h y d r a u l i c r e s e r v o ir
(22) Start and operate engine
(23) With engine operating at
times to remove air from
turn off engine.
(24) Check for oil leakage at
s a r y.
s e c u r e l y.
with oil (page 11-79).
a t i d l e s p e e d.
i d l e s p e e d,
extend and retract cylinders two
hydraulic system.
Lower bucket to ground and
all connections. Tighten connections as neces-
( 2 5 ) C h e c k h y d r a u l i c r e s e r v o i r o i l l e v e l ; a dd oil if necessary (page 11-78).
( 2 6 ) I n s t a l l e n g i n e r i g h t s i d e p a n e l s ( p a g e 9 - 1 7 ) .
11-49
