TM 5-3805-262-2011-3. LINES AND FITTINGS MAINTENANCE (CONT) e. Control Valve Assembly to Lift Cylinder Assemblies (cont).INSTALLATION (SHEET 1 OF 2)(1)(2)(3)(4)(5)(6)(7)(8)I f n e c e s s a r y,install new 0-ring (16) on two fittings (15).I n s t a l l f i t t i n g s ( 1 5 ) i n c o n t r o l v a l v e a s s e m b l y l i f t s e c t i o n p o r t s.Tighten securely.Install tubes (13 and 14) in loader.Loosely install four clamps (12), and two capscrews (11), lock washers(10), and nuts (9).Position tube (8) between tee located on tube (14) and fitting (15)installed in lower lift section port of control valve assembly. Ifnecessary, adjust position of tube (14), thenfittings on both ends of tube (8) securely.Position tube (7) between tee located on tubes t a l l e d i n u p p e r l i f t s e c t i o n p o r t o f c o n t r olnecessary, adjust position of tube (13), thenfittings on both ends of tube (7) securely.Tighten nuts (9) securely.connect and tighten(13) and fitting (15) in-valve assembly. Ifconnect and tightenInstall clamp on tube (8) and secure using capscrew, lock washer, andnut. Tighten nut securely.11-54
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business