TM 5-3805-262-20
CLEANING
(1) Clean hoses (3 and 4) using detergent; dry using clean cloths.
Dry cleaning solvent P-D-680 used to clean parts is toxic and flammable.
W e a r p r o t e c t i v e g o g g l e s a n d g l o v e s a n d u s e o n l y i n a w e l l v e n t i l a t ed
a r e a . A v o i d c o n t a c t w i t h s k i n,
e y e s a n d c l o t h e s a n d d o n ’ t b r e a t h e
vapors. Do not use near open flame or excessive heat and don’t smoke
w h e n u s i n g i t . F a i l u r e t o d o s o c o u l d c a u s e s e r i o u s i n j u r y . I f y o u
b e c o m e d i z z y w h i l e u s i n g c l e a n i n g s o l v e n t , g e t f r e s h a i r a n d m e d i c al
a t t e n t i o n i m m e d i a t e l y . I f c o n t a c t w i t h s k i n o r c l o t h e s i s m a d e , f l u s h
w i t h
w i th
(2)
l a r g e a m o u n t s o f w a t e r .
If contact with eyes is made, wash eyes
water and get medical aid immediately.
Clean remaining parts using cleaning solvent P-D-680; dry using clean
c l o t h s .
Compressed air used for cleaning purposes will not exceed 30 psi.. Use
o n l y w i t h e f f e c t i v e c h i p g u a r d i n g a n d p e r s o n a l p r o t e c t i v e e q u i p m e nt
( g o g g l e s / s h i e l d , g l o v e s , e t c ).
F a i l u r e t o d o s o c o u l d c a u s e s e r i o u s
i n j u r y t o e y e s a n d p o s s i b l e b l i n d n e s s .
If you hurt your eyes or if a
f o r e i g n o b j e c t i s b l o w n i n t o y o u r e y e s , s e e k m e d i c a l a t t e n t i o n
immediately.
(3) Flush interior of hoses (3 and 4) and tubes (7, 8, 13, and 14) using
clean hydraulic oil and compressed air to clear blockages as necessary .
INSPECTION
NOTE
Replace all parts determined to be defective in following steps.
(1)
Inspect hoses (3 and 4) for chafing, cracks, deterioration or damaged
t h r e a d s .
(2) Inspect tubes (7, 8, 13, and 14) for cracks, breaks, dents, or damaged
f i t t i n g t h r e a d s.
(3) Check fittings (15) and elbows (5) for cracks, breaks, deformation or
damaged threads.
(4) Inspect remaining parts for cracks, breaks, deformation, or damaged
t h r e a d s .
11-53
