TM 5-3805-262-20
REMOVAL ( SHEET 1 OF 2)
NOTE
To prevent foreign matter from entering hydraulic system, plug and cap
tubes and hoses disconnected or removed in following steps.
In following steps, identify and tag all hoses and lines before discon-
necting and removing to aid in installation .
(1)
( 2)
(3)
(4)
(5)
At left side of loader, loosen two tube fittings (1) and disconnect hoses
(3 and 4).
Loosen two fittings (2) and disconnect and remove hoses (3 and 4).
If necessary, remove two elbows (5) and 0-rings (6). Discard 0-rings (6).
Repeat steps (1) through (3) above to disconnect and remove hoses and
fittings from remaining lift cylinder assembly.
At center of loader, remove nut, lock washer, and capscrew securing clamp
to tube (8). Remove clamp from tube (8).
11-51
