TM 5-3805-262-20
INSTALLATION (SHEET 2 OF 2)
(9)
(10)
(11)
(12)
(13)
(14)
(15)
(16)
(17)
(18)
(19)
A t l e f t s i d e o f l o a d e r , install new 0-ring (6) on two elbows (5).
Install and tighten two elbows (5) in lift cylinder assembly port.
Route hoses (4 and 3) between elbows (5) and tube fittings (1). Connect
a n d t i g h t e n f i t t i n g s ( 2 ) a n d t u b e f i t t i n g s ( 1 ) s e c u r e l y.
Repeat steps (9) through (11) above to install and connect hoses (3 and
4) to remaining lift cylinder assembly.
Install tilt cylinder assemblies tubes (steps (1) through (7), page 11-46
and steps (16) and (18), page 11-49).
Fill hydraulic reservoir with oil (page 11-79).
Start and operate engine at idle speed.
With engine operating at idle speed,
extend and retract cylinders two
times to remove air from hydraulic system. Lower bucket to ground and
turn off engine.
Check for oil leakage at all connections. Tighten connections as neces-
s a r y .
Check hydraulic reservoir oil level; add oil if necessary (page 11-78).
Install engine right side panels (page 9-17).
11-57
