TM 5-3805-262-2011-6. HYDRAULIC RESERVOIR MAINTENANCEa. I n s p e c t i o n .This task covers inspection of hydraulic reservoir.MATERIALS/PARTS: Clean cloths (Appendix C, item 1)INSPECTION (SHEET 1 OF 2)(1)( 2)(3)( 4)(5)At front of loader, unlock and open access door and slowly loosen fillc a p ( 1 ) t o r e l i e v e a i r p r e s s u r e .Inspect hydraulic reservoir for hydraulic oil leakage at bottom. Checkreservoir for cracks, dents, or broken welds. If any of these conditionsare seen, report them to direct support maintenance.Remove fill cap (1) and 0-ring. Check fill cap for cracks, breaks, ordamaged or deformed threads. Check 0-ring for distortion or deteriora-tion. Replace 0-ring and fill cap if any of the above are seen.Inspect sight gage (2) for cracked, chipped, or broken glass. If any ofthese conditions are seen, drain hydraulic oil until oil level is justbelow sight gage tube (page 11-79). Then, remove sight gage using openend wrench and install new sight gage. Add hydraulic oil as necessary(page 11-78).Remove dirt and grease from sight gage (2) using clean cloth. Look atsight gage and see if hydraulic oil can be seen in gage. Add oil as ne-cessary (page 11-78).11-76
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
