TM 5-3805-262-2011-5. BUCKET CLAM CYLINDER ASSEMBLIES MAINTENANCE (CONT)b. Replacement (cont).INSTALLATION (SHEET 1 OF 2)(1)( 2)(3)(4)(5)(6)(7)(8)( 9)If necessary, position new 0-ringand 0-rings (10) in clam cylinderon elbows. Install and tighten elbowsassembly ports.Position clam cylinder assembly on rear of bucket.Aline cylinder tube yoke hole at bottom of cylinder with pivot hole inbucket.Start pin (8) into pivot hole at bottom of cylinder; be sure hole in pinis alined with hole in cylinder.Using hammer and 1-3/8 inches diameter rod, drive pin (8) into place.Apply Loctite 242 (blue) to threads of capscrew (7) and locknut (6).Install and tighten capscrew (7) and locknut (6) to 1000 to 1200 lb-ft.Connect and tighten hoses (1 and 2) to elbows installed in clam cylinderassembly ports.Start engine and operate at idle speed.11-74
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business