TM 5-3805-262-20
REMOVAL ( SHEET 2 OF 2)
(3)
When removing weld at bottom rear
of cutting edge, be careful not
to cut through bottom of clam.
S e e i l l u s t r a t i o n a t r i g h t w h i c h
shows construction of bottom of
clam.
(4) Using a grinder, remove any welds or extra metal on clam that will pre-
vent new cutting edge from fitting correctly .
INSTALLATION (SHEET 1 OF 2)
(1) Position new cutting edge in place and use C-clamps to hold cutting edge
i n p l a c e .
( 2 ) R e f e r t o f o l l o w i n g i l l u s t r a t i o n f o r w e l d s p e c i f i c a t i o n s . U s e E - 7 0 1 8 w e l d-
ing rod .
12-29
