INSTALLATION
TM 5-3805-262-20
NOTE
I f c o m p l e t e t o o t h a s s e m b l y i s b e i n g i n s t a l l e d , p e r f o r m s t e p s ( 1 ) , ( 2 ),
and (6) through (8) below. If new tooth point is being installed, go to
s t e p ( 3 ).
(1) Position tooth shank (6) and install 3 inches long capscrew (4) and 3-1/2
inches long capscrew (5).
(2)
Install and tighten two nuts (3). Tighten to 150 to 180 lb-ft.
Dry cleaning solvent P-D-680 used to clean parts is toxic and flammable.
W e a r p r o t e c t i v e g o g g l e s a n d g l o v e s a n d u s e o n l y i n a w e l l v e n t i l a t ed
a r e a . A v o i d c o n t a c t w i t h s k i n , e y e s a n d c l o t h e s a n d d o n ’ t b r e a t h e
v a p o r s . Do not use near open flame or excessive heat and don’t smoke
when using it. Failure to do so could cause serious injury. If You be-
come dizzy
a t t e n t i o n
with large
with water
( 3 ) C l e a n
w h i l e u s i n g c l e a n i n g s o l v e n t , g e t f r e s h a i r a n d m e d i c a l
i m m e d i a t e l y . I f c o n t a c t w i t h s k i n o r c l o t h e s i s m a d e , f l u s h
a m o u n t s o f w a t e r . I f c o n t a c t w i t h e y e s i s m a d e , w a s h e y es
and get medical aid immediately.
tooth shank (6) using stiff wire brush then use clean cloth moist-
ened with cleaning solvent P-D-680.
( 4 ) P o s i t i o n t o o t h p o i n t ( 2 ).
(5) Drive new roll pin (1) into tooth point (2) using hammer.
( 6 ) S t a r t e n g i n e a n d r a i s e b u c k e t .
(7) Remove supports from beneath bucket.
(8) Lower bucket and turn off engine .
12-27
