TM 5-3805-262-2012-3. LOADER BUCKET ASSEMBLY MAINTENANCE (CONT)d. Clam Bucket Cutting Edge (cont).INSTALLATION (SHEET 2 OF 2)WARNINGWear tinted protective goggles and insulatedacetylene torch and heated parts. Failure tofrom flame of torch or serious injury due toor burned, get medical aid immediately.gloves when working withdo so could cause blindnessburns. If you are injured(3) When welding top of cutting edge to clam:( a)Start at one end of clam and weld toward center until one welding rodis used.(b)Start at center of clam and weld in both directions until one weldingrod is used.( c)Start at other end of clam and weld toward center until one weldingrod is used .(d)Continue to weld cutting edgeedge is completely welded.( 4 ) I n s t a l l b u c k e t s h a n k a s s e m b l i e s( 5 ) C o n n e c t a l t e r n a t o r w i r i n g ( p a geto clam using this method until cutting(page 12-27).5 - 1 3 ) .(6)Start engine and raise bucket just enough to remove supports.(7) Lower bucket to ground and turn off engine.12-30
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
