TM 5-3805-262-20
REMOVAL ( SHEET 2 OF 2)
( 5 ) T u r n o f f e n g i n e .
(6) Loosen and remove 19 nuts (2) and bolts (1).
(7) Remove cutting edges (3 and 4) from blade (5).
INSTALLATION
(1)
( 2)
(3)
(4)
(5)
(6)
(7)
( 8)
( 9)
Hold cutting edge (3) in position and install several bolts (1) to hold
i t i n p o s i t i o n.
Install nuts (2) on bolts (1) already installed and install remaining
bo lt s an d nut s.
Tighten nuts (2).
Hold cutting edge (4) in position and install three bolts (1).
I n s t a l l a n d t i g h t e n t h r e e n u t s ( 2 ).
Repeat steps (4) and (5) above to install remaining cutting edge (4).
Start engine and operate at idle speed.
Open clam and remove blocks.
Raise bucket and remove supports from beneath blade.
(10) Lower bucket to ground and turn off engine.
12-25
