TM 5-3805-262-203-9. STARTING SYSTEM TROUBLESHOOTING (CONT)MALFUNCTIONTEST OR INSPECTIONCORRECTIVE ACTION1. STARTER DOES NOT CRANK (Cont).Step 6.Step 7.Connect multimeter between large left terminal of starter relay andchassis frame.Multimeter should indicate 24 volts.a. If multimeter indicates 24 volts, check wires between starterrelay terminal and 30 ampere circuit breakers. Replace wires asnecessary (page 5-26).b. If multimeter indicates zero, check cable between starter sole-noid BAT terminal and starter relay terminal. Replace cable asnecessary (page 5-16).At transmission controlvalve, connect multimeterbetween each terminal ofneutral start switch andchassis frame.T e l l a s s i s t a n t tonition key switchp o s i t i o n.Multimeter should24 volts for bothn a l s .a . I f m u l t i m e t erp l a c e i g-i n s t a rti n d i c a tet e r m i-i n d i c a t es24 volts for both termi-nals, go to step 8below.b. If multimeter indicates 24maining terminal, refer tob l e s h o o t i n g .volts at one terminal and zero at re-page 3-95 neutral start switch trou-C . If multimeter indicates zero for both terminals, check wiringconnection between neutral start switch and ignition key switchconnector START terminal. Repair or replace wiring or connectoras necessary (page 5-168 or 5-174)If wiring and connector are okay, remove right instrument panel(page 5-48) and replace ignition key switch (page 5-53).3-64
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
