2. OIL PRESSURE WARNING LIGHT DOES NOT OPERATE (Cont)

3. CLUTCH PRESSURE WARNING LIGHT DOES NOT OPERATE (Cont).

TM-5-3805-262-20 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
127

TM 5-3805-262-20 3-10. INSTRUMENT PANELS TROUBLESHOOTING (CONT) MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION 2. OIL PRESSURE WARNING LIGHT DOES NOT OPERATE (Cont). S t e p 2 . ( C o n t ). a. If oil pressure warning light is on, remove jumper wire and refer to page 3 - 93 sending units trou- b l e s h o o t i n g . b. If oil pressure warning light is not on, go to step 3 below. Step 3. Place ignition key switch in o f f p o s i t i o n. Remove sending unit resistor (page 5-112). Connect multimeter across ends o f r e s i s t o r. Multimeter should indicate 36 to 44 ohms. a. If multimeter does not indicate 36 to 44 ohms, install new re- sistor (page 5-114). b. If multimeter indicates 36 to 44 ohms, check wiring connection between sending unit, fuseholder, and instrument cluster for open circuit. Repair or replace wiring as necessary (page 5-168 or 5-174). If wiring is okay, reinstall resistor (page 5-114), remove in- strument cluster (page 5-34), and replace circuit board (page 5-39) . 3. CLUTCH PRESSURE WARNING LIGHT DOES NOT OPERATE. Step 1. Remove lamp (page 5-34) and connect multimeter across lamp contacts. Multimeter should indicate continuity. a. If multimeter does not indicate continuity, install new lamp (page 5-45). b. If multimeter indicates continuity, reinstall lamp (page 5-45) and go to step 2 below. 3-72

Privacy Statement
Press Release
Contact