TM 5-3805-262-203-25. HYDRAULIC SYSTEM TROUBLESHOOTING (CONT) MALFUNCTIONTEST OR INSPECTIONCORRECTIVE ACTION3 . BUCKET TILT CYLINDER ASSEMBLIES OPERATION SLUGGISH OR POOR (ALL OTHER CYLINDERSOPERATE PROPERLY) (Cont).S t e p 1 . ( C o n t ) .Clevis should move 0.44 inch approximately.Tell assistant to place BUCKET control lever in NEUT. position, thenmove it to DUMP position while you measure travel of clevis fromNEUT. to DUMP position.Clevis should move 0.44 inch approximately.a. If measurement is not 0.44 inch approximately, notify nexthigher maintenance level to adjust control valve assemblyl i n k a g e.b. If measurement is 0.44 inch, go to step 2 below.3-179
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business