TM 5-3805-262-203-33. STARTING SYSTEM TROUBLESHOOTING (CONT)MALFUNCTIONTEST OR INSPECTIONCORRECTIVE ACTION3. STARTER CRANKS SLOWLY (UNDER 200 RPM) (Cont).Step 15. Dial 89 into TEST SELECT.Measure voltage drop across each cable connected between batteries,starter motor ground terminal and battery negative post, and batterypositive post and starter solenoid BAT terminal.Do this by connecting test probe cable W2 clip test leads across ca-ble to be measured.Step 16.Press and release TEST button.Crank engine then return ignition key switch to off position.Voltage drop on VTM display should be less than 0.2 volt.a . I f v o l t a g e d r o p i s m o r e t h a n 0 . 2 v o l t , d i s c o n n e c t c a b l e . C l e anterminals that cable was connected to and cable terminals .Reinstall cable and repeat above test. If VTM still displaysover 0.2 volt, replace cable (page 5-158).b. If voltage drop is less than 0.2 volt, check for loose or corro-ded connection between starter solenoid MTR terminal and startermotor positive terminal. Remove connector between these twoterminals and check for dirt or corrosion.Dial 89 into TEST SELECT.Measure voltage drop across each cable connected between starterrelay end terminals and starter solenoid BAT and S terminals.Do this by connecting test probe cable W2 clip test leads acrosscable to be measured.3-283
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business