TM 5-3805-262-20
3-33. STARTING SYSTEM TROUBLESHOOTING (CONT)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3. STARTER CRANKS SLOWLY (UNDER 200 RPM) (Cont).
Step 16. (Cont).
Press and release TEST button.
Crank engine then return ignition key switch to off position.
Voltage drop on VTM display should be less than 0.2 volt.
a. If voltage drop is more than 0.2 volt, disconnect cable. Clean
terminals that cable was connected to and cable terminals.
Reinstall cable and repeat above test. If VTM still displays
over 0.2 volt, replace cable (page 5-16).
b. If voltage drop is less than 0.2 volt, go to step 17 below.
3-284
