TM 5-3805-262-20
REMOVAL (SHEET 2 OF 2)
(d) Loosen two tube fittings (4) then disconnect and remove tube (5) from
air compressor.
(e) Remove two capscrews (6), nuts (7), and lock washers (8); remove
governor (9) from mounting bracket (10).
INSTALLATION
( a )
(b)
( c )
(d)
( e )
( f )
(g)
Position governor (9) on mounting bracket
capscrews (6), lock washers (8), and nuts
(10). Secure using two
( 7 ) ; t i g h t e n s e c u r e l y .
Position and connect tube (5) to elbows installed in air compressor and
governor. Tighten two tube fittings (4).
Connect air hose (3) to governor port and tighten.
Connect air hose (1) to tee (2) located at top of air reservoir and
t i g h t e n .
Connect alcohol evaporator line and fitting to governor (page 7-122).
Close drain valve located in bottom of air reservoir.
Adjust governor (page 7-100).
7-99
