TM 5-3805-262-20INSTALLATIONDry cleaning solvent P-D-680 used to clean parts is toxic and flammable.W e a r p r o t e c t i v e g o g g l e s a n d g l o v e s a n d u s e o n l y i n a w e l l v e n t i l a t eda r e a . A v o i d c o n t a c t w i t h s k i n,e y e s a n d c l o t h e s a n d d o n ’ t b r e a t h ev a p o r s ,Do not use near open flame or excessive heat and don’t smokew h e n u s i n g i t .F a i l u r e t o d o s o c o u l d c a u s e s e r i o u s i n j u r y . I f y o ub e c o m e d i z z y w h i l e u s i n g c l e a n i n g s o l v e n t , g e t f r e s h a i r a n d m e d i c ala t t e n t i o n i m m e d i a t e l y . I f c o n t a c t w i t h s k i n o r c l o t h e s i s m a d e , f l u shw i t h l a r g e a m o u n t s o f w a t e r.If contact with eyes is made, wash eyeswith water and get medical aid immediately.(1)( 2 )( 3)( 4 )( 5)(6)If necessary, apply adhesive to pad(s) (19) and place in position onder (17 or 18). Remove excess glue using clean cloth moistened withcleaning solvent P-D-680.Position and support rear fender (17 or 18) on rear chassis.f e n -Install two washers (14), sleeves (15), washers (16), capscrews (13),washers (12), lock washers (11), and nuts (10). Tighten capscrews andn u t s s e c u r e l y.Install washer (9), capscrew (8), lock washer (7), and nut (6). Tightencapscrew and nut securely.Install seven washers (5), capscrews (4), washers (3), lock washers (2),and nuts (1). Tighten capscrews and nuts securely.Repeat steps (1) through (5) above to install remaining rear fender asn e c e s s a r y.9-29
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business