TM 5-3805-262-20
REMOVAL
(1)
(2)
(3)
(4)
(5)
Remove seven nuts (1), lock washers (2), washers (3), capscrews (4), and
washers (5).
Remove nut (6), lock washer (7), capscrew (8), and washer (9).
Support rear fender (17 or 18) and remove two nuts (10), lock washers
(11), washers (12), capscrews (13), washers (14), sleeves (15), and wash-
ers (16). Remove rear fender (17 or 18).
If necessary, remove pads (19) only if worn or damaged. Remove by scrap-
ing from fender (17 or 18) using a putty knife or other suitable tool.
Repeat steps (1) through (4) above to remove remaining rear fender as
n e c e s s a r y.
CLEANING AND INSPECTION
Dry cleaning solvent P-D-680 used to clean parts is toxic and flammable.
W e a r p r o t e c t i v e g o g g l e s a n d g l o v e s a n d u s e o n l y i n a w e l l v e n t i l a t ed
a r e a . A v o i d c o n t a c t w i t h s k i n,
e y e s a n d c l o t h e s a n d d o n t b r e a t h e
v a p o r s.
Do not use near open flame or excessive heat and dont smoke
w h e n u s i n g i t . F a i l u r e t o d o s o c o u l d c a u s e s e r i o u s i n j u r y . I f y ou
b e c o m e d i z z y w h i l e u s i n g c l e a n i n g s o l v e n t , g e t f r e s h a i r a n d m e d i c al
attention immediately. I f c o n t a c t w i t h s k i n o r c l o t h e s i s m a d e , f l u s h
w i t h l a r g e a m o u n t s o f w a t e r .
If contact with eyes is made, wash eyes
with water and get medical aid immediately.
(1) Clean all parts using cleaning solvent P-D-680; dry using clean cloths.
(2) If a pad (19) was removed , use clean cloth moistened with cleaning sol-
vent P-D-680 to remove all traces of pad (19) and adhesive.
(3) Check rear fenders (17 and 18) for cracks, breaks, dents, or excessive
corrosion. Remove corrosion using a stiff wire brush. Touch up all bare
metal areas using MIL-C-46168 paint, color forest green.
( 4 ) I n s p e c t r e m a i n i n g p a r t s f o r c r a c k s , b r e a k s,
d i s t o r t i o n , d e f o r m a t i o n , a nd
damaged threads. Replace as necessary.
9-27