TM 5-3805-262-2010-4. WINDSHIELD WIPER MOTOR MAINTENANCEa. W i p e r M o t o r.This task covers removal, disassembly, cleaning, inspection,reassembly, and installation of the wiper motor assembly.TOOLS: No. 1 Common Organizational Maintenance Tool KitFixed open end wrench setSocket wrench set, 3/8 inch driveS c r e w d r i v e r s e t , c r o s s t i p , s t r a i g h t , a n d o f f s e tMultimeterLong nose pliersMATERIALS/PARTS: Clean cloths (Appendix C, item 1)Cleaning solvent P-D-680 (Appendix C, item 2)Detergent (Appendix C, item 3)Insulation tape (Appendix C, item 5)Isopropyl alcohol (Appendix C, item 15)Boot (FSCM 10988 PN D71420)Felt washer (FSCM 10988 PN D71417)PERSONNEL REQUIRED: Two Construction Equipment Mechanics M0S 62B (Removal only)NOTEPRELIMINARY PROCEDURE: Battery ground cable disconnected (page 5-148)and wiper arm removed (page 10-12).REMOVAL(1)( 2 )( 3 )( 4)(5)(6)(7)At front of loader cab, pull boot (1) from wiper motor assembly (10)s h a f t .Loosen and remove nut (2).Loosen and remove two capscrews(3) and lock washers (4).Remove adapter (5) and gasket( 6 ).Inside cab, remove wiper motorassembly cover (7) by liftingstraight up off wiper motor as-sembly (10).Identify, tag, and disconnectthree wiring harness spadeterminals (8) from three wipermotor assembly terminals (9) bygrasping wiring harness termi-nal using long nose pliers andpulling firmly from wiper motorassembly terminal.Remove wiper motor assembly(10) from cab.10-13
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business