TM 5-3805-262-344-3. TRANSMISSION MAINTENANCE (CONT)a. TransmissionTorqueConverterGroup(Cont).REMOVAL (SHEET 2 OF 3)( 4)(5)(6)( 7)( 8 )( 9)( l o)(11)(12)(13)Use pry bar to separate conver-ter cover (6) from converterpump (29).Remove turbine housing (21) andassociated parts (15 thru 20)as an assembly from converterground sleeve.Remove seal (7) from converterpump (29).Using retaining ring pliers,remove retaining ring (8) se-curing stator (9).Remove stator (9) and spacer(10) from converter groundsleeve.Using hammer and chisel, bendtabs of lock plates (23) awayfrom capscrews (22) heads.Loosen and remove two cap-screws. Capscrews must be atopposite sides of converterpump (29) to allow installationof puller screws.Install puller screws in holesof converter pump (29) fromwhich two capscrews (22) wereremoved.Operate puller and pull conver-ter pump (29) from its seat inconverter ground sleeve. Removepuller from converter pump.Remove converter pump (29) andassociated parts (22 thru 28)from converter ground sleeve.Remove seal (11) from converterground sleeve.4-96
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business