REMOVAL (SHEET 3 OF 3)
(14) Using a hammer and chisel, cut
a slot in diaphragm (13). Put a
pry bar in slot and bend top of
slot out and bottom of slot in.
This will distort diaphragm to
allow its easy removal.
(15) Pull diaphragm (13) with oil
seal (12) installed from con-
verter ground sleeve and dis-
card.
NOTE
Do not perform following
step unless inspection
LEGEND
1.
2*
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
140
15.
16.
17.
18,
19.
20.
21.
22.
23.
plug (14) from
verter housing
Discard plug.
Capscrews (6)
Retaining plate
Flex plate disks
Flex plate disk
Lock nuts (24)
Converter cover
Seal
Retaining ring
Stator
Spacer
Seal
Oil seal
Diaphragm
Plug
Turbine pins (6)
Turbine
Turbine assembly
Bearing
Retaining ring
Bearing
Turbine housing
Capscrews (12)
Lock plates (6)
TM 5-3805-262-34
4-97
