REASSEMBLY (SHEET 2 OF 2) - TM-5-3805-262-34

c. Transmission Turbine Driven Gears and Freewheel Unit cont - TM-5-3805-262-34_1087

c. Transmission Turbine Driven Gears and Freewheel Unit cont - TM-5-3805-262-34_1089

TM-5-3805-262-34 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
1069

TM 5-3805-262-34 4-3. TRANSMISSION MAINTENANCE (CONT) c. Transmission Turbine Driven Gears and Freewheel Unit (Cont). REASSEMBLY (SHEET 2 OF 2) (8) Install two capscrews (12) through freewheel cam (7). Install freewheel cam, roller cage (8), and spring retainer plate (9) on second turbine driven gear (16). Use two capscrews to aline these parts. (9) Install remaining ten capscrews (12) and secure using 12 new lock nuts (6). (10) (11) (12) (13) Put freewheel unit in soft jawed vise. Tighten every other lock nut (6) to 41 to 49 lb-ft until all lock nuts are tight. Remove freewheel unit from vise. Put oil-soluble grease on 15 rollers (5). Install 15 rollers in roller cage (8) pockets. Install bearing spacer (2) on shaft of second turbine driven gear (16). Put first turbine driven gear (1) on second turbine driven gear (16) shaft with hub of first turbine driven gear (1) against rollers (5) in free- wheel unit. (14) Push down and rotate first turbine driven gear (1) in counterclockwise direction. As first turbine driven gear is rotated, its hub will engage rollers (5) and first turbine driven gear will slide into position. (15) Put freewheel unit in hydraulic press. Position bearing (4) on shaft of second turbine driven gear (16). Using 1-1/2 inches inside diameter sleeve, press bearing (4) onto second turbine driven gear shaft. (16) Install bearing spacer (3) on bearing (4). Position second bearing (4) on second turbine driven gear (16) shaft with numbers on it facing up. Using 1-1/2 inches inside diameter sleeve, press bearing onto gear shaft until bearing is in con- tact with bearing spacer. 4-144

Privacy Statement
Press Release
Contact