CLEANING - TM-5-3805-262-34

REASSEMBLY (SHEET 1 OF 2) - TM-5-3805-262-34_1143

TM-5-3805-262-34 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
1123

TM 5-3805-262-34 4-3. TRANSMISSION MAINTENANCE (CONT) h. Transmission Housing (Cont). CLEANING Dry cleaning solvent P-D-680 used to clean Wear protective goggles and gloves and parts is toxic and flammable. use only in a well ventilated area. Avoid contact with skin, eyes and clothes and don’t breathe vapors. Do not use near open flame or excessive heat and don't smoke when using it. Failure to do so could cause serious injury. If you be- come dizzy while using cleaning solvent, get fresh air and medical attention immediately. If contact with skin or clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes with water and get medical aid immediately. Compressed air used for cleaning purposes will not exceed 30 psi. Use only with effective chip guarding and personal protective equipment (goggles/shield, gloves, etc). Failure to do so could cause serious injury to eyes and possible blindness. If you hurt your eyes or if a foreign object is blown into your eyes, seek medical attention immediately. (1) (2) (3) (4) Remove all gasket material from transmission housing (13) using clean cloth moistened with cleaning solvent P-D-680. Dry using compressed air. Immerse transmission housing (13) in cleaning solvent P-D-680 and agitate cleaning solvent. Let housing soak for 15 minutes. Remove housing from bath. Dry using clean cloths. Use compressed air to clean out oil holes and recesses in transmission housing. Immerse suction tube (11) in cleaning solvent P-D-680 and agitate cleaning solvent. Let suction tube soak for 15 minutes. Remove suction tube from bath. Dry using clean cloths. Use compressed air to clear and dry inside of suction tube. Clean remaining parts using cleaning solvent P-D-680. Dry using clean cloths. INSPECTION (1) Inspect transmission housing (13) for cracks or other damage. Inspect bores for scratches, wear, or grooves. Check that recesses are free of foreign matter. If necessary, clean housing again. Replace transmission if transmission housing requires replacement. Replace (2) Inspect (3) Inspect 4-198 NOTE an item if inspection indicates need for replacement. suction tube (11) for cracks, dents, or other damage. remaining parts for cracks, wear, or thread damage.

Privacy Statement
Press Release
Contact