TM 5-3805-262-34INSTALLATION (SHEET 2 OF 3)LEGEND1. Lock nut2. Washer3. O-ring4. Output flange5. Oil seal6. Retaining ring7. Bearing8. Output shaft9. Transfer gear10. Spacer11. Oil seal12. Bearing13. Plug(10) Install washer (2) and new locknut (1) on output shaft.(11) To prevent rotation of outputflange (4), install flangeholding tool on output flangeand secure using two 7/16-20NFby 1 inch capscrews as shown.(12) Tighten locknut (1) to 450 to700 lb-ft.(13) Remove two 7/16-20NF by 1 inchcapscrews and flange holdingtool from output flange (4).(14) Install spacer (10) on opposite end of output shaft (8).4-193
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
