TM 5-3805-262-344-3. TRANSMISSION MAINTENANCE (CONT) i. ControlValve(Cont).DISASSEMBLY (SHEET 2 OF 3)(5)(6)(7)(8)(9)Pull trimmer valve plug (6)from body (29) using slip jointpliers.Remove regulator valve spring(7), retainer (8), and trimmervalve spring (9).Remove plug (10) and gasket(11). Discard gasket.Put plug (10) in soft jawedvise. Using drive pin punch,push piston (13) from plug.Remove and discard seal (12)from piston.Remove clutch(29) port.cut off valve (14) and spring (15) from control valve bodyNOTEIn following step, spring tension is against plug (16). Be sure toloosen plug first, then hold against spring (18) tension and remove.(10) Loosen plug (16). Hold plug against spring (18) tension and remove plugand gasket (17). Discard gasket.(11) Remove detent spring (18) anddetent ball (19).(12) Remove plug (20) and gasket(21). Discard gasket.(13) At rear of body (29), use ascrewdriver and remove valvestop (22).(14) Using punch and hammer, drivevalve spool (24) until oil seal(23) is pushed from body (29).4-204
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business