4-7. TRUNNION ASSEMBLY MAINTENANCE

INSTALLATION (SHEET 3 OF 3) - TM-5-3805-262-34_1201

REMOVAL (SHEET 2 OF 2) - TM-5-3805-262-34_1203

TM-5-3805-262-34 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
1183

TM 5-3805-262-34 4-7. TRUNNION ASSEMBLY MAINTENANCE This task covers removal, cleaning, inspection, and installation of trunnion assem- bly. TOOLS: No. 1 Common Organizational Maintenance Tool Kit Hand hammer, 16 ounces Slip joint pliers Safety glasses Socket wrench set, 3/4 inch drive Torque wrench, 3/4 inch drive Brass rod, 1-3/4 inches diameter Steel rod, 2-1/4 inches diameter Chain hoist Tap, 5/8-11 MATERIALS/PARTS: Clean cloths (Appendix C, item 1) Cleaning solvent P-D-680 (Appendix C, item 2) Grease (Appendix C, item 11) Lock plates (FSCM 10988 PN L12824) REFERENCE: TM 5-3805-262-20 NOTE PRELIMINARY PROCEDURE: Rear axle removed (page 3-386) and lubrication hoses and fittings disconnected from trunnion assembly (refer to TM 5-3805-262-20) . REMOVAL (SHEET 1 OF 2) a. Support trunnion assembly (9) at both ends b. c. Be sure rear chassis is securely supported is securely attached to trunnion assembly ing steps. Failure to do so could cause using chain hoist. and blocked and chain hoist (9) before performing follow- serious injury or death by equipment falling on you. . If you are injured by falling equipment, obtain medical aid immediately. Straighten tabs of two lock plates (2) using pliers. Remove four capscrews (1), two lock plates (2), and trunnion retainers (3). Discard lock plates. NOTE Use chain hoist, attached to trunnion assembly pivot pins (7) before performing step d below. (9), to reduce tension on 4-258

Privacy Statement
Press Release
Contact