TM 5-3805-262-34
REMOVAL (SHEET 2 OF 2)
LEGEND
1. Capscrews (4)
2. Lock plates (2)
3. Trunnion retainers (2)
4. Washers (2)
5. Washers (2)
6. Washers (2)
7. Pivot pins (2)
8. Bushings (2)
9. Trunnion assembly
10. Rear chassis
d. Drive two pivot pins (7) outward using 1-3/4 inches diameter brass rod and
hammer just enough to remove washers (4, 5, and 6). After removal of washers,
drive pivot pins from trunnion assembly (9) and rear chassis (10) trunnion
supports.
e. Lower both sides of trunnion assembly (9) evenly and remove from under rear
chassis (10).
NOTE
Don’t perform step f below unless inspection indicates replacement of
bushings (8) is necessary.
f. Press two bushings (8) from trunnion assembly (9) using 2-1/4 inches diameter
steel rod. Discard bushings.
4-259
